|
STEPS |
DESCRIPTION |
NOTES |
|
Step #1 |
Soak a soft and adsorbent hand-towel in warm water, then extract by squeezing any excess water; Try by touching it the towel around your penis to make sure that it’s a temperature appropriate; | Step #1 to #3 are warming-up steps. This is important because it helps to make blood stream to the penis. The slightly wet heat also make the penis’s skin more soft, which shall ensure a better grip for upcoming wearing traction device. Sometimes when remove the towel then your penis may look of a light shade of red due to the increased flow of blood. Don’t worry, this is a normal situation. Some men have a higher tolerance for heat, so the penis may not look any different. |
|
Step #2 |
In flaccid or erect condition, cover entire your penis (including the head) by towel; hold the towel in the position for about 3 to 5 minutes; then remove the towel; | |
|
Step #3 |
Make dry your penis with another one towel; | |
|
Step #4 |
Make your penis in semi-erect state (1/2 or 3/4 erect); | Wear the device from 2 to 8 hours a day (depending on your preference). It is not advised to wear the device more than 8 hours a day (you must give your penis a chance to recover and rebuild tissues, effectively enlarging itself day by day). |
|
Step #5 |
Open the silicone loop (ring) then enter over head to the base of your penis base of through the plastic SizeGenetics™ device; | |
|
Step #6 |
Strap the soft SizeGenetics™ comfort pad into the device; | |
|
Step #7 |
Now pull the loop down carefully until the head is secure; | |
|
Step #8 |
Finally, do a little adjustment of the device to the penis for your comfortable. |
Don’t delay to enlarge your penis, ORDER your SizeGenetics™ today
*******